CLS37PC Software


This software allows a CLS 33/37 with Zilog Computer or a PC152 single board computer, to be connected to a Pentium PC running Windows 98, eliminating the need for the 8" floppy drives which may be removed from machine. The PC downloads CLS37 DOS into the Zilog's memory directly. It allows laser trim jobs to be uploaded and downloaded onto the PC hard drive.

Note: If the machine is a CLS 33, a Crystal change to the autocut board is required along with a backplane modification. These changes can be done inhouse.

Florida Laser Service can supply the following required hardware:
  • Replacement Crystal for Autocut Card
  • Pentium PC, Keyboard, and Monitor

  • The time at Florida Laser Service in West Palm Beach Florida is